Springs Window Fashions Traverse Rod Installation

Hanging window treatments is straight forward. Right measurements will go a long mode to ensure an installation that is a cakewalk!

Hanging stationary window treatments. If you are using a decorative curtain rod for your stationary window treatments, such every bit tailored drapery panels, you may employ a variety of different methods to hang your new window treatments.

Rod pocket. Simply slide the rod through the rod pocket and adjust the textile so that it falls in fifty-fifty folds.

• It is sometimes helpful to place a pocket-sized plastic bag over the finish of the rod and then that it does not snag the fabric.

• Conform the rod so that it and window treatments are the advisable width.

• Slide the rod onto the brackets, and adjust the cloth then that it falls in even folds.

• Secure the sides with tiebacks, if desired.

Decorative rods with rings. Put the rings on the rod while adjusting the rod to the appropriate width if you will be using decorative rings. Slide the rod onto the brackets.

• Make sure to evenly space the fabric and prune the rings to the window treatments.

• One time all the rings are used, adjust the spacing so that the cloth falls in even folds.

• Secure the sides with tiebacks, if desired.

Hanging operational window treatments. The almost common hardware used for operational window treatments is a traverse curtain rod, which features plastic carriers channeled in a metal runway, that are guided and moved by cords and pulleys.

Traverse curtain rods are more often than not used with pinch-pleated draperies, but tin can as well be used with other types of window treatments. Y'all will need mantle pins or hooks to adhere the cloth to the plastic carriers.

• Slide the pointed cease of the drapery pivot / hook up through the dorsum of the fabric.

• Be conscientious to keep the hook inside the textile, so it does not show in the front.

• Use 1 drapery pin/hook for each pleat, or every bit space the hooks beyond the fabric.

• Make sure that the hooks are all at the same altitude from the top of the panel header (top part of the fabric.)

• Generally, the drapery pins/hooks should be placed low enough so that the fabric completely covers the traverse rod anywhere from ¾ to 1 ¼ inches below the peak of the header, depending on the traverse rod.

Once all the drapery pins/hooks are in place, y'all are ready to hang the draperies. Use the cords of the traverse rod to place the rod in the closed position, and then that the plastic carriers are evenly spaced beyond the window.

• Start from ane stop and hook the draperies onto the rod.

• The commencement and 2d hooks on each side should exist attached to the fixed end of the traverse rod.

• Once all the drapery pins/hooks are attached, you may remove whatever unused plastic carriers.

Now, you tin can use the cords to open and close your window treatments!

CWF PRO TIPS: Helpful tips for installation.

• Heavier curtains, tailored drapery panels will require a thicker drapery rod.

• Traverse rods that split in the centre (aka heart draw) when opened tin easily be converted to a one-manner depict configuration, to open either to the left or the right. This is helpful when dressing patio or sliding doors that offering i-manner access.

• Whatever cord describe traverse rod can exist converted to a baton depict by simply removing the cords and purchasing drapery wands.

Share this post